Hein (fub) wrote,
Hein
fub

  • Mood:

Ho-hum

The photosensitive plates I ordered (the cheapest I could find) are OMG thin. That's not much of a problem though -- it means I can cut the boards to size with scissors.
I etched the boards for the miniPWM and for the matrix driver, but unfortunately the layouts were mirrored. I need to check this before I start etching. :(

I did solder the PCB for the miniPWM -- I just put the IC socket on the copper side, the rest of the components don't care about being reversed (resistors, condensators) or could easily be reversed without any ill effects (78L05, elco's). And it worked!

Tomorrow I'll re-etch -- I still need to confirm the layout before I send it off.
Tags: electronics project, webshop
Subscribe

  • Sinterklaas & rhymes

    On a whim, I had bought chocolate capitals for the two colleagues who are in my project, plus for the key people at the client. I wrote Sinterklaas…

  • BlinkenLEDs -- the final frontier

    This evening, I produced the final version of the firmware for the single-matrix BlinkenLEDs circuit. This one has it all. If you recall, I have two…

  • Another day, another blinkenLEDs mode

    So I had this idea yesterday... if I make a large display with multiple LED matrices on top of eachother, wouldn't it be cool to have a…

  • Post a new comment

    Error

    Anonymous comments are disabled in this journal

    default userpic

    Your reply will be screened

    Your IP address will be recorded 

  • 0 comments